Mazda 2003 Protege5 Specifiche Scaricare il pdf (Pagina 21)

Bulletin No: 07-002/09

Last Issued: 06/24/2009

Page 21 of 32

5. Shake a bottle of Mazda Air Cooling Coil Coating well and attach it to the applicator, then connect the appli-

cator to compressed shop air.

6. Insert the applicator into the empty filter housing (approximately 4-1/4 inches from the tip of the applicator).

Point the nozzle tip downwards and towards the center (approximately the 7 o’clock position).

7. Spray the entire contents of the bottle in short bursts, 3 seconds ON, 3 seconds OFF into the rotating fan. A

fine mist may exit from the ducts.

8. When the bottle is empty, stop the engine and remove the applicator.

NOTE: For reuse, clean the applicator by flushing a bottle of clean water through it.

9. Install the previously cleaned or new filter as needed and reinstall the filter cover

10. Reinstall the glove box.

11. Use STEP 1 to dry and cure product for 5 minutes instead of 15 minutes.

2000-2003 MPV Rear AC (if equipped)

12. Remove the right side cup holder.

13. Remove and disconnect the rear fan control panel and convenience tray, if equipped.

14. Be sure the HVAC controls are set per STEP 1B (see page 16).

NOTE: The rear fan will operate even though the rear fan control panel is disconnected.

15. Shake a new bottle of Mazda Air Cooling Coil Coating well and attach it to the applicator, then connect the

applicator to compressed shop air.

02_1053k

INSERT

APPLICATOR

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Nessun commento

Mazda 2003 Protege5 Specifiche Pagina 21