Mazda Remote Start System Manuale di Installazione Scaricare il pdf (Pagina 2)

2 | P a g e

You also have an antenna, a small pushbutton and a status LED. The antenna should be mounted near the top of the

windshield, at least 1” away from metal. Route the antenna cable underneath the headliner, down the windshield pillar

and around the end of the dash. Carefully tuck the cable in behind the trim panels. The pushbutton is typically

mounted in the driver’s kick panel (that’s the area forward of the door), the driver’s side of the center console, or the

underside of the dash. Installation requires drilling a small hole in the plastic. The LED is not required for operation,

but is helpful for programming or diagnostics. It also requires a hole and can be placed either near the pushbutton or on

top of the dash.

Reading your wiring chart

Each line of the wiring chart contains 3 pieces of information that you will need (continued on next page):

 The “Function” column tells you what the wire function is

 The “Equipped” column tells you the color of the wire in the car

 The “Type” Column shows the location of the wire in the vehicle

 The “last column tells you the polarity of that wire, where applicable

*Some wiring charts will include a column titled “Available Kits”. Disregard the information in this column. The

information in this tip sheet is more concise.

The sample below will show you where to find that information on your chart.

Making your wiring connections

The table on the following page will show you where to connect the wires from your remote start into the car. Any

wires on your remote start that are NOT listed in the table are NOT USED.

Helpful Hint: In most cases, the wires on the remote start are way longer than needed. Trim off excess wire when you

make your connections, but leave some slack - this will allow you a little flexibility when it comes time to stow the

remote start module after the installation is completed.

See Installer’s Tip # 2 on Page 5 for tips on how to make your wiring connections

1 2 3 4 5 6 7

Nessun commento

Mazda Remote Start System Manuale di Installazione Pagina 2